i am having to move my 2 batteries(24v) to the rear of my boat. i am using 6 awg fro my batteries to my plug. the wire on the motor is 10awg. it is a 65lbs thrust minn-kota. all the plugs i have found have been 10awg on both side and i dont want the wire behind the plug getting hot under my deck.

 

i found these.

http://www.bestboatwire.com/anderson-sb50-6-awg-gray

 

any feed back on this item or one good for my setup?

how about these two paired up?

 

http://greatlakesskipper.com/lund-2005936-marinco-2018bp-24-marine-boat-male-trolling-motor-plug-4-pin

 

http://greatlakesskipper.com/tracker-220-02445-h-boat-trolling-motor-harness-w-50-amp-shortstop-breaker#

http://store.minnkotamotors.com/products/418633/Trolling_Motor_Plug_

 

Marineco makes this for MinnKota

I really think you're worrying too much about this but here's the best plug out there. http://www.boatstore.com/ranger-trolling-motor-plug-and-receptacle-trolling-motor-plug-display-pack.html?utm_source=googlepepla&utm_medium=adwords&id=22209859648&gclid=CKjdzabZtb8CFQaJaQods44Aug

http://www.boatstore.com/ranger-trolling-motor-plug-and-receptacle-trolling-motor-receptacle.html

there's no wires on either side, you wire runs directly to the terminals.