I got a 35mm gomexus power knob and installed it per instructions = starting with empty shaft 1. Washer (they give you super thin ones) 2. bearing 3. attach inner handle 4. add bearing 5. put in screw through bearing and tighten 6. screw 2nd bit of handle. BUT you can pull up the handle on the shaft just a bit which is annoying, there's just a little play, but feeling the handle not be tight down is crappy. Thing is if I add a second washer in step 1, the handle will loosen itself when it spins which is weird because the washers are ultra thin, I dunno if its a friction thing of if the washer moves it up too much but it is weird.  

I've installed too many ShimanoA DaiwaS handle knobs to count.  

If that last shim washer is either too much or too little installed at the inner bearing, try installing it under the knob spindle screw.  

 

 

I always wonder where these people go...

Edited June 10, 20214 yr by bulldog1935