Flatfish Posted May 30, 2005 Share Posted May 30, 2005 This is probally a silly question but, when using a depth finder is the depth shown on the screen the actual depth from the surface or from where the transducer is located. Quote Link to comment Share on other sites More sharing options...
GobbleDog Posted May 30, 2005 Share Posted May 30, 2005 I think it's from the transducer, unless you programmed the unit to adjust. Quote Link to comment Share on other sites More sharing options...
Muddpuppy Posted May 30, 2005 Share Posted May 30, 2005 I always asumed the transducer. Quote Link to comment Share on other sites More sharing options...
Skeeter_Madness Posted May 31, 2005 Share Posted May 31, 2005 It reads from the transducer unless you calibrated your unit. You can calibrate your depth finder to read either from the Transducer, or the surface--your choice. It should be covered in your manual if you still have it. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.