yum

Does anyone know if the hole,opening under the shaft on the up and down adjustment bracket on the motorguide tour trolling motor is to route the transducer cable-older model Thanks

Has anyone used the Helix 7 MSI GPS G3 on the bow and was it affective or do u wish you had the DI at trolling motor without MI Thanks

Will be buying new electronics next spring and will probably be Humminbrid helix 5,7,8, or 9 inch. Would you get mega si/di on console and bow or maybe just the di on the bow which is the way I’m leaning thanks for any and all input

This is probably a silly ? but i have some spinning reels that are 4.8.1,5.2.1,5.8.1 and a couple in between these and i am trying to figure out the inches per handle turn to try to get reels of 100yds each out of 1 200 yd spool of fluoro. I was thinking of going with 25 for all and hopefully being within a FEW yds on all of them-WOULD THIS WORK? OR SHOULD I JUST BUY MORE AND FILL THEM UP AND NOT WORRY ABOUT GOING BROKE BUYING FLUOROCARBON????

I have 5 fuses at the console and looking at them the tops (lying on back looking up) of all 5 are connected together. Now 2 of the 5 have no connectors on the bottoms of them and i am wondering can i hook to 1 of them for power for my gps? and run my front graph to the other (battery interference).And if i can where does the ground wire to the gps hook 2? Seperate from that is a 1 inch by 3 inch plastic plate with terminals on it with 3 or 4 openings on it -would this be power also or maybe the grounds????? I would rather not run wire to battery for gps if i dont have to.Thanks for any and all help CRAZY

Does anyone use fluoro. on spinning gear for senkos,tubes,shaky heads,ect.? If so what brand is best?Handling,Sensitivity,ect. Always have used mono. with no problems but maybe its time i get with the times OR is there a BETTER WAY? THANX FOR ANY INPUT.