- Tackle Box Gear
-
I suck at using Shakey Heads
Hey jb_adams, very nice write up. I learned a lot.
-
what gauge wire?
When I rewired my boat I bought a big ol set of jumper cables, cut the ends off and ended up with some really nice wires for my trolling motor
-
Hello from East Kentucky!!
Surferdave, Grayson is one of the prettiest lakes you will find around here and that's about the only good thing I can think of to say about it, This spring I did catch a 3.5 pounder out of it and that was by far the largest bass I ever caught out of there, now Yatesville has been tough for the past couple of months but you can expect to catch a keeper or two when you go. When you decide to fish Yatesville let me know and I'll fill you in on what's working, right now a C-rig on deep points is working well. If you find a spot on cave Run that isn't full of weeds with some fish on it please let me know, if I can catch 1 or 2 over the slot I might win.
-
Hello from East Kentucky!!
Hi Surferdave, I'll fish Cave Run a couple times a year, I have a tournament there 9-22-07. So what's the lake like? crystal clear and full of weeds? I know a lot of good fish come out of Cave run but it's so big and seeing how I'm only there two times a year at most I've had a hard time learning much about it. Last year I did fairly well around the camp ground with a white spinner bait, any edge I could find in the weeds I would throw at it, picked up my limit of small ones in a couple of hours then went looking for something bigger but didn't have much luck. I fish Grayson a few times a year but I'm on Yatesville a couple times a week.
-
Hello from East Kentucky!!
Welcome from Ashland KY.
-
Trolling Motor intermitent
Maybe a bad circuit breaker, the 90 seconds down would give it time to cool off and reset it's self
-
Replacement handle for Shimano Scorpion 1000 mg
I would like to replace the handle on my scorpion with something a bit longer, about the only thing I've found is a carbon fiber handle that sells for around $100 but I don't want to put that much money into one. Anyone know of a cheaper solution? My reel has a nut holding the handle on. Thanks
-
motor problems
Sounds like a fuel delivery problem. First off you won't want to run it for very long like that, if it's running lean on fuel it's running out of oil also. My guess would be the fuel pump, the pulse hose going to it or the primer bulb in the fuel line, if you have someone with you have them squeeze the primer bulb while it's acting up, if it takes off you will know its fuel. You might want to go ahead and replace the fuel line and primer bulb it won't cost too much and they do cause problems from time to time.