David Duffer

I just bought a 16 ft aluminum Jon/bass conversion has a 40hp Mercury Force... I am wanting to redo front and rear decks and not a very good carpenter.. So if I may I would like to bounce some ideas off you follows and see what you thank ok., I am using an Evinrude bow type trolling motor with three forward speeds also reverse. I am thanking of cutting framing and using piano type hinges on two wide doors where deck meets the floor, having them open like a door.. To store all life jackets & vest. On right side have a box type kinda like a locker laying on it's back to store poles and have a turn key lock on it... Now for rear after removing all broken foam in boat thanking of having a hatch type door on storage on both right & left sides in rear corners...If I can place batteries in them with I am running two to make 24volts.., And I want to make a long have type door again with a piano hinge..., Sorry to write so much but what do you thank... Also I have found a decal stripes off for a Tracker bass boat that I want to put down each side of boat with my boat type written in it too, is Aluminum Craft.. Stripe is red and black and my two pole type seats are by Wise and they have a wide stripe like in both back and seat with red and gray so thanking of carpeting floor deck and around steering wheel podium to with some kind of red., Thanks everyone... Sorry mistaken side right but mint to say left but if there is room on right side before you get to steering wheel podium may try to fit another pole holder locker..