I had a question about the pop rivet of the buzzbait. I was going to tweak them. I bought 1/8 mm rivets. Thats the only smallest size at the hardware store. When I compare it up to the actual size rivet on the buzzbait, the 1/8 mm is a bit bigger. Will this pop rivet still work for the buzzbait even if its a little bigger head? Buzzbaits are 1/4 oz, 3/8 oz, 1/8 oz. There Calvitron Buzzbaits. Pictures below!

 

Pm your address and I'll drop a couple in the mail for ya if the larger one doesn't work.

I don't see a problem using the larger one though.

Pm your address and I'll drop a couple in the mail for ya if the larger one doesn't work.

I don't see a problem using the larger one though.

would you use the larger one 1/8 mm pop rivet? Or would you buy one thats the exact size of the pop rivet it came with?

To be honest I would try the large one, but its hard for me to tell based on the pic if it would work or not. Put it on and see if the prop freely spins.

To be honest I would try the large one, but its hard for me to tell based on the pic if it would work or not. Put it on and see if the prop freely spins.

it freely spins theres enough room for the prop to move up and down just not at much as it would with the smaller pop rivet

You're good to go then.

Pm your address and I'll drop a couple in the mail for ya if the larger one doesn't work.

I don't see a problem using the larger one though.

I will send u a pm, are the rivets steel or aluminum?