I was just wondering what grit of sandpaper to use to get a good shine on my gelcoat,its an 88 stratos,has a couple spots that are not smooth,i would like to smooth it out so she shines,any info would be appreciated,thanks

 

^{http://www.amazon.com/Meguiars-Marine-Fiberglass-Restoration-System/dp/B0000AY4YT}

If you absolutely have to sand I would use 1600 or 2000 and wet sand it.

I used 3m restorer and wax. It worked wonders. You can check the thread out here:

http://www.bassresource.com/bass-fishing-forums/topic/96810-oxioxydmy-boat-was-cloudy/?hl=%2Bima+%2Bbass+%2Bninja#entry1070283

I would strongly advise against sanding unless you have alot of experience. If you must use a super fine wet dry sandpaper and wet sand. The top coat is thin and is easily marred.

Thanks,i would rather not sand if i don't have to

I used Zing on my boat and it worked wonders. I just cut it 50/50 with water and applied it with a scrub brush and just let it sit for a little bit and then hosed it off.

 

http://www.zingboatcleaners.com/

 

Here are some pics only using Zing, this was before I washed and waxed it.