Im having soo big problems...ok the airbrush worked great the first couple of days i cleaned it out after every use with water ..now i went to use it and it sprays for a little while then it stops even when there is alot of paint in the cup and the brush just sprays air and when i go to look at the adjustable tip the inside needle is covered in paint?? im using a paashce VL seris nothing great but a good starter..please help me haha

Try adding some reducer to your paint. It sounds like your paint is drying too fast.

Eric

Extender not reducer.

Eric

Thanks what about the paint getting on the inside needle is that common? and whats the best way to clean the airbrush when im done?

sorry about the second post but what else could the problem be if it isnt the paint drying soo quick?

If you are cleaning the brush with water and windex between colors, I do not know what would allow paint to dry on the interior part of the needle.

Has your needle gotten bent at all?

I make sure that I clean well between colors and spray a cup of windex and water. This normally is all I need to do to ensure the internal portion is clean while spraying. After all spraying is complete I tear the brush down and soak in water and Dawn dish detergent for 2 hours.

Eric

I use cheap acrylic paints so I always have this problem. I just keep a wet Q-tip close by, and when the tip dries, I stick it into the tip and give it little twist and I'm back in bid-ness.