Hey guys. So I was fishing today and my trolling motor (Minn Kota Turbo 32 lb) slid down from the mount. It ended up being long enough in the water to reach a log with it hit and the prop popped right off onto the edge of the screw. I didn't think anything of it so I put it back in the water and started it again. It ends of spinning off the edge of the screw and I lost it. I have two questions. What prop can I buy that will fit the old white turbo 32 lb thrust minn Kota? And what can I do about the trolling motor sliding down the mount? I have tightened the screw as tight as I can to make the motor stay up but it keeps sliding down. Any help it appreciated. Thanks!

You'll have to measure the diameter of the lower end of your trolling motor. It should fit the same prop as the new ones do, but I could be wrong. It sounds like you're missing a part though. There should be a collar on the shaft above the mount that you slide down to ride on top of the bracket.