Looking for some insite on marbling. What epoxies seem to be best "i would assume high build" or what pigments to use. Also if you have any techniques you want to share it would be much appreciated

I use high build and timing is everything for different effects from the marbling.  I have CRB pigments and testors model paint.  

Ok. What does timing have to do with it? I guess ill have to practis

Ok. What does timing have to do with it? I guess ill have to practis

Ok. What does timing have to do with it? I guess ill have to practis

 

From the time you get it mixed, the consistency of the finish gets thicker by the minute until it sets. The longer you wait to add the finish mixed with the pigment, the sharper and more defined the marbling will be.  The earlier you do it, the more fluid the mix is, and it moves and blends more.  The great thing about marbling is you never quite know for sure how it's going to look until the next day when it's dry.

From the time you get it mixed, the consistency of the finish gets thicker by the minute until it sets. The longer you wait to add the finish mixed with the pigment, the sharper and more defined the marbling will be.  The earlier you do it, the more fluid the mix is, and it moves and blends more.  The great thing about marbling is you never quite know for sure how it's going to look until the next day when it's dry.

 

That, for me, is the problem. I have an idea, or a look I'm going for, then get something I like, and the next day it's different. Been working on scrap pieces of blank, not on any real rods so far.

 

It seems simple; wait until the epoxy has thickened a bit and proceed. Do it too soon, and it all runs together. So, wait longer, right? Wait long enough to get some decent separation, and you get threads stringing out from the tool that go anywhere except where you want them to go.

 

I'll keep experimenting. I've seen some that look really good. It may be a while before I get to that point.

Much like guide wrap finishing, you just have to experiment and find what works for you. There are so many variables it's hard to say for someone else. So far, Flex Coat High Build has a pot life and consistency that works well at around 70*F room temp.