and it works fine...........

A 6" x 2" (12 ga.) galvanized hurricane clip from Home Depot bent in half with two of the holes drilled out to 1/4". Cut a 1 3/4" slit horizontal from the top and bend in to fit the original bracket and trim sides to desired length.

Simple but effective 15 minute DIY.

8-)

If your buying hurricane clips at Home Depot, you must be a Florida Resident! ;D

If your buying hurricane clips at Home Depot, you must be a Florida Resident! ;D

And an ultra rare pre-rat factory (Disney) "FL Native" to boot

We are a dying breed!!!!!!

I agree on that 200%.......

Now I'd just like to figure out how to get the hydrilla out of west lake or we need another hurricane to get the water back up

Some are on the beds, but in deep water.

There's no echo from that metal sitting so close to the cone????  

Fortunately, My 'ducer fits nicely behind the skeg.  8-)

Fortunately, My 'ducer fits nicely behind the skeg. 8-)

Mine too.

There's no echo from that metal sitting so close to the cone????

It's not as close as the picture may look. There is about a 1/2" clearance around it.