I have a 13 1/2 foot Boston Whaler. It currently has an electric anchor system, with the anchor coming down off the right front of the boat. It is a donut type anchor. It didn't take long last year to realize that one anchor would not hold me in position. Do you advise putting a second anchor off the back? If so, should it also be on the right side of the back or left side? I Don't want another electric system. I also feel that a different type anchor might be better, at least at one end of the boat. What type would you recommend. Most of my fishing is on lakes with varied bottoms. Sorry that was so long winded, but wanted to be as clear as possible. Thanx! A Bunch.

Tri-fluted or river anchor; your bow anchor is too light  

The donut I have is 18 lbs.  How heavy do I need.  How about using the one I have in the stern and getting a new fluted or river anchor for the stern?  Thanks for the reply.

18 pounds should be enough but mushroom/doughnut anchors are almost useless on hard bottoms.

Mushroom

Tri-fluted/river

A small Danforth anchor might just be what you need. Problem with most anchors not holding is not enough rode and the angle the anchor is resting at on the bottom doesn't allow the flukes to dig in. You can also try putting about 2 - 3 feet of chain between the anchor and anchor rope which will help make the anchor lay down and bite into the bottom. To free up a Danforth that has bitten in, just position the boat directly over the anchor and pull straight up. Used one on all my sailboats from 23' - 30'. Work great!

Thanx Catt and Popeye.  I really appreciate the help.  I an a true newbie.  Just got out with a friend a few times last year and got hooked (no pun intended.)  Been a flyfisher for lots of years, but am really looking forward to going after some bass, crappie and pike this season.  I know I will be spending some time on these forums learning the ropes.  

Thanx Again!