Jump to content
Sign in to follow this  
92 5 oh

how to get lower unit off of mercury 25 hp?

Recommended Posts

help!

i was going to check the impellor and i couldn't figure out how to get it completely seperated.  it seemed like either the drive shaft or shift linkage was holding it together. i was reading various sites and some suggestions were check inside the trim tab, take out the 2 water inlets, put it in forward. none of these helped. i removed the starter and could see the shift linkage where it goes down to the gear case but i couldn't figure out how to detach it anywhere. i noticed if i put it in reverse i could get about an inch between the lower and mid section so i was able to at least look at the impellor.  (everything was fine).  so im' going to order a service manual since my local library didn't have one to look at.  in the meantime, can anyone tell me how in the world to get this thing apart in the event i need to go back into it?  oh ya, it's a 2001  

thanks

steve

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.

  • fishing forum

    fishing

    fishing rods

    fishing reels

    fishing forum

    fishing

    bass fish

    fish for bass
    fish

×