Skip to content

Butt Cap ID

Leeosbc
in Rod Building and Custom Rods

Featured Replies

Hello All,

 

I'm getting into rod building and I had a question regarding butt caps. I've recently found a style that I really like (see attached) but it looks like the ID (0.250") on the butt cap is significantly smaller than the butt on the blank (0.50") that I want to use. Is there a way to effectively bore out the ID of the butt cap so that it will fit on the rod blank? 

 

Thanks!

Butt Cap.PNG

  • Quote

    A gentleman showed me how he uses step drip bits to get the right size hole and finishes with a Forstner bit. I haven't tried it yet, but his was a clean job.

  • Quote

    • Join the conversation

    You can post now and register later. If you have an account, sign in now to post with your account.
    Note: Your post will require moderator approval before it will be visible.

    Guest
    Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
    Reply to this topic...
    Go to topic listing

    Recently Browsing 0

    • No registered users viewing this page.

    Important Information

    We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.

    Account

    Navigation

    Search

    Search

    Configure browser push notifications
    Chrome (Android)
    1. Tap the lock icon next to the address bar.
    2. Tap Permissions → Notifications.
    3. Adjust your preference.
    Chrome (Desktop)
    1. Click the padlock icon in the address bar.
    2. Select Site settings.
    3. Find Notifications and adjust your preference.