I dont know how it happned but i was just looking at my guides on my veritas and one of them as bent down, I bent it back up but some of the epoxy on it had chipped off. Not the epoxy on the blank covering the thread, but around the base of the guide. I have some devcon 2-ton and Im wondering if i put a little bit around the bottom if everything will be ok?

Patching will be unsightly. If the thread covering is not compromised I'd leave it alone and just keep an eye on it. Worse case is moisture gets underneath and the epoxy continues to peel. If that happens you rewrap and finish the whole wrap.