rswell2

What about a BB gun instead of a shotgun?

Similarly to the last question about weight, what about durability of something like #4? Is that something you're going to have to be extra careful with? Could it hold up to 'reasonable' conditions?

What kind of support did you use under your floor?

When you put the floor in the middle of the boat, was it "level"? I have a similar, though much older, v-hull that I would like to put a floor in. I don't have the middle seat section like you have, so I wouldn't have to cut out that section. It just seems like when I put the plywood in to fit, the whole piece angles downward toward the front of the boat. Will that change when I get it on the water?

Its sad what can happen to a perfectly good body of water. After watching the video, it almost looks like they're the only ones on the water aside from the paddle boat at the beginning. Do people just avoid this section of the river all together?

#4 Red Cedar and Pine Very very nice.

I agree with FishingBuds: Could you explain the flooring around your rear seat?

Could you explain "best previously adhered surface"? My brothers and I are working on a 67 starcraft. It has white outside walls that seem to be in ok shape, but we would like to update it a little. I was under the impression that we could sand down any bad spots, spray the primer just on any bare metal spots, and finish off with the polyurethane coating. Should we sand the whole boat to bare metal? If we don't, do we need to prime the entire boat?