Wired Wrong

Thanks for all the replies I found group 24 AGM batteries and all is good now.

I have a 2000 Triton TR 20 I have converted from 24 volt to 36 and used group 24 batteries, its time for new ones and the type I want I can only find in group 27 which are too long for my battery tray, I read somewhere to cut the end of the tray and use ratchet straps to secure them. Where would I attach the ratchet straps? The battery space is really tight and hard to reach. Thanks for any advice.

Thanks for all the replies,I will continue to use the palomar knot.

Anyone use the Palomar know with fluorocarbon line? I have heard yes and no,what does this group advise?. And what is considered the best knot for fluorocarbon? Thanks

Yes it sounds like something is scrubbing.Fast or slow reel.

i removed the line and lubed where I could reach without complete disassembly.

I called Shimano last week and the guy I spoke with said to send them in to be checked,but it was a 4-6 weeks turnaround. Trying to find a fix that I can do.

These reels are basically new with less than 100 cast on them, But I will lube them again.Thanks for your response.

I have 4 of these reels and all have less than 100 cast,and 3 of the 4 sound like this.I have several older Curados that don't do this. I have lubed the brake dru and spool rod,worm gear etc.But I can do some again.Thanks for the replies.

Can anyone provide a cure for this noise? I have tried oiling the brake drum but it didn't help.Thanks

Thanks for all the replies,I have many options/ideas that I didn't have before.

I searched but didn't find what I needed. I am looking for thin,waterproof,warm gloves For the cold, wet ,fishing days.If anyone has any info or suggestions it would be appreaciated.

I had to buy longer cables, circuit breaker and remove a wire from the plug up front,and 3 new batteries.

Yes I finished the project,it was easier than I thought.I am up and running with 36 volts and a new Minn Kota Ultrex.

I had to buy 3 batteries and couldn't handle the cost of Lithium.

Thanks

I have a 2000 Triton TR 20 and am wanting to convert to 36 volts for trolling motor,has anyone done this ? Any tips on fabrication for an extra battery? Thanks

How many here use snap swivels on spinning gear to reduce line twist?Are they needed on crankbaits for line twist? Thanks

I have 6 of the Supremes that I have had for about 17 or mores years I guess and I have not had any issues at all,and they have been used a lot.I don't know about the new ones.

Merry Christmas,Happy Hooking

Thanks for the response and info men.Guess I am going to glue it inside

I recently installed the above noted unit on my boat and mounted the transducer to the transom as per Humminbirds instructions,but it will not read on plane,Humminbird says I have to move it around to find the right spot.I don't want to drill anymore holes in my boat.. My question is will the Down Image read through the fiberglass hull if I glue it inside?Thanks

Thanks for your reply sir.

I am upgrading my electronics and will need to use a ram mount . The angle that the mount will be to use the Helix 7 is my concern. will the tension stay tight and not let the unit move in rough water.Thanks