Reyn

I need to replace the in line fuse for my Bass raide 10 E. I can not find the 50 amp replacement fuse anywhere. Any suggestions? Thanks.

Thanks fishcat. I'll try to find the photo you mentioned.

I have a pellican 10E with the trolling motor mounted on the front transome. I would like to purchase a Hummingbird Fishin Buddy 120 and mount it in the front, but the transome has no room left to mount it. Question: Is there a spot in the front that a Fishin Buddy can be mounted other than the transome? Thanks.

Bomber7, I have all of the toys to hook up my trolling motor on the bow like your set up. Question: Are both of the negative wires from the Big Foot switch connected on the same negative wire coming off of the bow plug? It kind of looks like that from your #2 photo. Is that a three wire connection under that glob of tape under the bow plug. If so, how exactly what did you use to make the three wire connection. Thanks, Reyn

Thanks Bomber7, I failed to mention that I also planned to hook up a plug too. I'm sure your set up will work for me but, the second photo looks like an electrician's nightmare (to me, a dummy). Perhaps your video will help. Good luck uploading it. The photos will help though. Thanks again.

I'm ready to pull the trigger on a Minn-Kotta Traxxis 45# thrust motor for my Bass Raider 10E. I plan on mounting this on the front transom connecting this to a Big Foot switch and a rudder on the rear transom. The Big Foot Switch will be attached to to a carpeted plywood floor? Question For you folks that have a similar set up, how do you take your trolling motor off if it is connected to the foot switch. Do you have an electrical connection that you can unplug from the rest of the hook up? I was thinking of attaching the foot switch to the carpet with Velcro, unless a detachable connection would be better. Any suggestions would be appreciated. Thanks.

Do you use any type of sealant?

tfultz, Since you've mounted so many items to your Bass Raider, I was wondering how you go about doing it. I plan on ordering paddle clips like yours, but didn't want to take a chance of compromising the integrity of the hull. Thanks.

For you folks that made a rudder for the your Raider, what dimensions did you find worked best for the flat part of the rudder?

Just seen one in a Bass Pro catalog. I'm not sure of the price, but I would guess 50% cheaper. Only the rails looked square.

For you folks that have mounted a rudder on a trolling motor mount, what's the best length for the D.I.Y. shaft?I think, I remember reading 30" from the mount, but I just wanted to check with those of you on what's working for you. I just bought a new mount on eBay.

Thank you for the replies to my question. So point hunter 75, you just used the vinegar and that was it? Sounds easy enough. Thanks again.

Thank you for the replies to my question. So point hunter 75, you just used the vinegar and that was it? Sounds easy enough. Thanks again.

I remember somewhere In the 82 pages there was someone talking about putting stickers for boat registration on the Bass Raider and what you needed to do. I would appreciate any advice.