ko4nrbs

I found a spot with many rocks, chunks of concrete, and an old culvert all under water. I happened upon this spot channel cat fishing. Caust a nicne 2 1/2 pond small mouth there with a minnow under a cork. I tried weighted bullet jigs but kept getting hung up. Any suggestions on lures that can get down in the rock and concrete without getting hung up? Bill

These measurments are for my Minn Kota Edge 70 ft. lb. motor. Measurement "A" is 13 5/8" and measurement "B" is 6 3/4". The propeller and skeg are on different ends of the motor. Based on these measurements and the fact that the Nose/Cone is higher than housing they recommended the following: 1. TM-HDSI-S $ 79.95 2. 2 HDTS- 3 1/2 Straps 5.95 ea. 3. Strip $8.95 Bill

I saw it. Thought I would share it in case it may help someone else. By the way thanks for all your help!! Bill

Here's the drawing. Bill

Don't now if I am brave enough to try that. Bill I have a .PDF file from Transducer Shield and Saver that shows what measurements they need but can't get it to load here. Bill

I contacted Transducer Shield and Saver already and they ask me to take some measurements. I'm at my daughter's place now in Boston. MA and won't be back home to Oklahoma for a couple of weeks. I'll get it done when I get home. Helping her out with carrying for her newborn daughter. Minn Kota told me there is 6 inches between the prop and the skeg. Just don't know yet if I can make it work. May have to look for an alternate way if I keep this transducer. Thanks Wayne and Goose52. Bill

Has anyone installed a Hummingbird XTM-9-HDSI-180-T transducer on a Minn Kota EDGE 70 ft. lb. trolling motor? Did it fit ok? Thanks, Bill