Here is what I just got threw pouring.

Nice looking, maybe i shoulda waited before i placed my order. lol  Keep up the good work  

Very nice. Is that a custom mold? Also where did you get the spiral wire at? Hate to be so nosey, but I sure would like to make some. Just so darn expensive to buy.

thomas

It is a do-it mold that I grinded on. The wire is a Hitch Hicker.

Now I have to Kill Ya. LOL

Fedxpress

Hey,

Did you just make a thin slot for the small part of the hitchhiker and then open it up wider to fit the coil part of the hitchhiker?  I thought of doing that w/my roundhead jig mold, I figured that it would still be able to pour regularly w/only a small bit of flashing that'd be easy to take off.  I also figured if you did it the way I said that you never would have to put a pin in like you do w/poison's or other weedguarded molds.  sorry if my post was just plain confusing, but I bet those who are doing this understand.

Yea I just made a little slot for the shaft and then gound out for the whole spring to fit into.

Now Im going to have to kill ya. LOL

Fedxpress

It all started by making these for a guy to use for Red Fish. The jigs have a 5.0  Gamakatsu hook.

These are for soft plastics.

Fedxpress

I am a total noob, but what are these shaky jigs for?  I don't understand them, apart from a normal jig...  Thanks!

u screw a strait tail worm on the spring/screw, and rig it weedless...cast it in and jig it on the bottom

That makes sense.  Thanks for that help!  I have to get me some of these, then...