Skip to content

Powder Coat Steel Bullet Weights

Gamec0cks5
in Tacklemaking

Featured Replies

So I have some ultra steel bullet weights that are shiny and I wanted to coat them and was wondering how I could do it with bullet weights? I have seen the how to videos on painting jigs and SW Jigheads, they hold it with the forceps and heat it then dip in paint and cure in a oven.

So how do I do it with bullet weights?

  • Quote

    get some .030" to .060" stainless steel wire depending on the hole size of the weight.  Put a short 90degree bend on one end and slip it through the weight.  Powder paint and cure.

  • Quote
    • Author
    get some .030" to .060" stainless steel wire depending on the hole size of the weight. Put a short 90degree bend on one end and slip it through the weight. Powder paint and cure.

    ;) That is a good idea, i didn't think about that

  • Quote

    • Join the conversation

    You can post now and register later. If you have an account, sign in now to post with your account.
    Note: Your post will require moderator approval before it will be visible.

    Guest
    Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
    Reply to this topic...
    Go to topic listing

    Recently Browsing 0

    • No registered users viewing this page.

    Important Information

    We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.

    Account

    Navigation

    Search

    Search

    Configure browser push notifications
    Chrome (Android)
    1. Tap the lock icon next to the address bar.
    2. Tap Permissions → Notifications.
    3. Adjust your preference.
    Chrome (Desktop)
    1. Click the padlock icon in the address bar.
    2. Select Site settings.
    3. Find Notifications and adjust your preference.