Jump to content
Sign in to follow this  
IN2FISHIN

HELP! LMS480 water temp not working.

Recommended Posts

My water temp reading did not show up on the screen last time I used it. I went to overlays and removed it than added it back in, now it shows a blinking 32* reading! Anyone have a solution for my problem?

Thanks

Share this post


Link to post
Share on other sites
My water temp reading did not show up on the screen last time I used it. I went to overlays and removed it than added it back in, now it shows a blinking 32* reading! Anyone have a solution for my problem?

Thanks

Try the standard computer remedy for most of those type of problems.  Disconnect the power source for a minute or so.  Then reconnect it.  Hopefully that will take care of it.

Share this post


Link to post
Share on other sites

I am not sure of the proper key strokes for that unit so check your manual and try a soft reset.  If that doesn't work then try a hard reset.

Back up your waypoints on an SD card before you do the resets.

Share this post


Link to post
Share on other sites

Thanks for all the responses! I did try the soft reset with no success so I tried the hard reset with same results! I think George is right, the sensor has taken a dive! Thanks Again!!

Share this post


Link to post
Share on other sites

Check the line to see if there might be a small nick in it.  That can cause all kinds of trouble.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.

  • fishing

    fishing forum

    fishing rods

    fishing reels

    fishing

    bass fish

    fish for bass
    fish

×