My water temp reading did not show up on the screen last time I used it. I went to overlays and removed it than added it back in, now it shows a blinking 32* reading! Anyone have a solution for my problem?

Thanks

My water temp reading did not show up on the screen last time I used it. I went to overlays and removed it than added it back in, now it shows a blinking 32* reading! Anyone have a solution for my problem?

Thanks

Try the standard computer remedy for most of those type of problems.  Disconnect the power source for a minute or so.  Then reconnect it.  Hopefully that will take care of it.

Sounds like your sensor bit the dust.

I am not sure of the proper key strokes for that unit so check your manual and try a soft reset.  If that doesn't work then try a hard reset.

Back up your waypoints on an SD card before you do the resets.

Thanks for all the responses! I did try the soft reset with no success so I tried the hard reset with same results! I think George is right, the sensor has taken a dive! Thanks Again!!

Check the line to see if there might be a small nick in it.  That can cause all kinds of trouble.