Jump to content
Sign in to follow this  
DaveT63

Cast control knob has no effect?

Recommended Posts

I have 2 reels that the cast control knob has no effect on.  A Scorpion 1001XT and a Core 51Mg7.  I must have done something wrong when I pulled and flushed or just oiled the bearings.  But both look right when looking at the schematics.  Anyone have any suggestions I could try?

Thanks,

Dave

Share this post


Link to post
Share on other sites

I just ran into a similar problem with my curado 200i. it turns out I didn't have the spring seated properly. check to see that its in right and that you can tighten the cap all the way down. when my spring wasn't in right I had no tension control at all. once I fixed it, it was normal again.

  • Like 1

Share this post


Link to post
Share on other sites

Make sure you put all the parts back right side up.  Sometimes just flipping a washer makes a difference.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.

  • fishing

    bass fishing

    fishing forum

    fishing rods

    fishing reels

    bass fish

    fishing

    fishing poles

    fishing reels
    fishing reels

    fishing

    bass fish

    fish for bass
    fish

×