Skip to content

Live well conversion to Trolling motor Battery Box

Featured Replies

Hello friends, this is my first boat, and I am figuring it out as I go. I have two live wells in the bow of my boat (1993 monark 1700DC). I would like to convert one of them to a battery storage for a trolling motor. The plan is to disconnect the fill pump (it's a tee fitting I will replace with an elbow fitting). I will put a plug in for the drain to keep any water out.

 

Has anyone ever done this modification before? Any tips or suggestions. I don't want to ruin a couple batteries due to ignorance.

 

Thank you in advance!

It should work as long as you ensure that all the water ingress points have been dealt with.  It would also pay to have a way to drain it in the event you swamp the boat, rain, etc.

 

One thing I can think of, TM batter compartments are typically along the centerline to keep the boat level.  As you mentioned 2 batteries (24 volt?) you may want to test it.

 

Most important advise I have is as follows:

  • Use a good quality battery tray to prevent damage from bouncing around (bow moves more than the stern)
  • Hard wire it to the TM rather than use a plug. Its more reliable
  • Use a properly sized disconnect switch, circuit breaker, and cables.

PM me if you need help.

  • Author

The plan is to do a 24v set up. You make a good point with a circuit breaker. I will be sure to wire one in to prevent any serious damage to my trolling motor in case something does go wrong.

 

Thank you Puggz for the advice ?!

  • Super User

one of my concerns would be the ability of the livewell to support two batteries.  Is it a plastic tub type liner or is at an aluminum box?  If it's the metal box, I wouldn't worry about it.  If it's the plastic, I doubt there's enough support beneath it to keep the batteries from going through it in time.

  • Super User

livewells do not have heavy walls and I would think a battery would break through it the first wave you hit hard. Put the batteries as far back as possible the the rear. Front livewells make good dry storage units for light weight items like clothing, towels, rain gear etc.

Tom

  • Super User

What's the logic of putting the batts up front?

  • Super User

Probably the best place for the batteries is midship.  I installed an accessory battery in the back of my boat once to run the graphs.  My boat ran like a$s with the extra weight back there. Lost 4mph on the top end and had waves knock me off plane occasionally.  I moved it up to the battery compartment in the middle of the boat and all was good again.

  • Super User

Glass Bass boats plane on a very short area at rear of the boat called a pad. Any weight foreword of the pad must be lifted out of the water by engine angle to increase boat speed. Tunnel hulls and hydroplane hulls have longer plane surfaces; the prop and sponsons, air becomes the lifting surface and weight can be moved forward.

It's always a balancing act to attain maximum speed, weight foreword defeats speed unless the boat is under powered and can't attain enough speed to ride on it's pad. Displacement hulls run faster with centered weight balance.

Tom

  • Super User

Generally, the best place is where the manu puts them.  I know a guy that put his in the front livewell of his tracker 170, and it's not fun to get up on plane.

  • Author

They are aluminum live wells. The only reason I am putting them in the bow is because I have an enclosed transom. One side I have a built-in fuel tank (a stray spark and fuel make a bad plan) the other side I have storage for a starting battery. In the middle of the transom is a small storage compartment (couldn't fit a better there). I do have a live well in the stern I could convert. The batteries would then be all in one side of  the boat. At least  in the bow I can try to keep it centerd. The boat doesn't seem to have much trouble getting on a plane if I have the motor trimmed right for the speed. With a deep-v hull I should be ok right?

  • Super User

Aluminum and battery acid aren't compatible in enclosed spaces. You will need to vent the boxes with good airflow. Plastic battery box with a strap tie down and use AGM battery that doesn't leak fumes or acid may work. 24V TM's were around in the late 80's, why your '93 Monark bass boat doesn't have battery space is unusual.

Tom

 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

Recently Browsing 0

  • No registered users viewing this page.

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.