So I have been researching and trying to find a good injector for plastisol and I have been trying to find all the supplies for for making my own worms 

Google bait making sites under ground.  You will find one that has every thing you need to know.

 

thank you so much I am looking it up now... 

I looked it up, and I didnt find anything super helpful but thank you. I might use it for later referance.

Spend your money on the injector, don't go cheap. I have the Basstackle, and if I wanted out of pouring I could get my money back in less than a week. The high end stuff barely depreciates. 

 

Also get a nice respirator, and make sure you have ventilation.

 

The rest is up for debate, some guys use a microwave, others a presto pot... Some guys like Dead on Plastic, others prefer other brands. 

 

I use both ways to heat plastic and primarily pour remelts from guys who pour for profit. I don't sell stuff, I keep my fishing buddies stocked and I donate bags of baits to local high school teams. 

1 hour ago, PourMyOwn said:

Spend your money on the injector, don't go cheap.  

Great advice! Get one with a locking nozzle as the first one I bought didn't. After blowing the nozzle of a few times I just bought a good one (think its as Basstackle?).

 

Allen

thank you so much I have seen the injectors on amazon and read the reveiws on there injectors and they all said you need a injector with a locking mechanism so thank you 

16 hours ago, IneedAnewScreenName-974534 said:

thank you so much I am looking it up now... 

I looked it up, and I didnt find anything super helpful but thank you. I might use it for later referance.

You should read don’ts for newbies for sure.

4 minutes ago, Jig Man said:

You should read don’ts for newbies for sure.

ok i will