Long story short, I dropped the spool tension knob of my Revo Toro Winch, and the washers came off the knob. I put them back together and the reel is working fine.

I'm looking at the schematic (see pic). The parts that came off, and I put back, are #60 and #59.

I'm wondering what are the parts #62 and #61? More precisely where are these located? Are these fixed inside the metal cap itself, or on the reel?

I'm not sure if I dropped them as well, and lost them.

#61 & #62 are the shim (brass) and it's (black rubber) backer.

They should be located in the upper part of the clicker assembly #63....

#61 & #62 are the shim (brass) and it's (black rubber) backer.

They should be located in the upper part of the clicker assembly #63....

Okay, got it. I took off #60, and looking down, I can see the shim. So I'm guessing the backer is still behind it, and I didn't lose either of those. Thanks a lot.

Another quick question, does it matter which way I install #60? It looks identical from either side, with the exception of a dimple on one side.

If its badly dimpled and you are losing spool tension range, then replace it. Otherwise, it's normal wear.

If its badly dimpled and you are losing spool tension range, then replace it. Otherwise, it's normal wear.

no, no. it's a brand new reel. Part #60 is some sort of a metal disc, and the dimple is at one end (almost on the circumference). I'd take a photo, but it's too small.

Anyway, I tried it both ways, and the clicker seems to work better one way over the other. I think I'll leave it as it is.

You can flip the shim over in the meantime but all means replace it if worn.