warrior1

about two weeks old the only thing I've done to the boat in the last couple of months is add a trim blinker switch

I unplugged my boat and the cranking battery drained in a couple of days. The power switch at the console is off and I did a drain test by taking out each fuse but that all checked out. I thought I read somewhere that a bad alternator might do that when it sits, but I can't find the article, so not sure if I remember that correctly. Any suggestions? And thanks in advance...

Thanks, I followed your suggestion; one is pending

Can anyone tell me why I don't have the Down Imaging screen on my finder. Everything else is there, 2d sonar, GPS etc. but no option to view DI. I have the correct transducer installed; the graph is up front, with the transducer on the trolling motor

I have a 2014 Nitro and will be changing my graphs; one will be a side scan. where would be the best spot to put the transducer?

I have three batteries, but my cranking is still good, so I'll wait on that one.

yes, sorry I meant Optima (blue tops)

I currently use two interstate 29 batteries for my trolling motors but one has died. I have an opportunity to get two Optima R34m's for basically the price of one. I do fish a lot of tournaments and was wondering if the two AGM's are comparable to my 29's and will my Dual Pro 15 Amp/Bank Professional Series 3 Bank Charger be OK in charging them.

Deciding between something in the M-1 line or an X10 or X11 for my square bill rod. Any thoughts would be appreciated. I'm only interested in Phenix comparisons please. thanks

My Guest charger lost one of it's banks after 2 years, so I'm in the market for a new one. It was only a two bank charger, which is what the Nitro came with, so I will be moving up to a 3 bank unit now. I am looking at the Dual Pro Professional or Sportsman, so my question would be for anyone that has either to give me their thoughts. I'm not sure if the Professional is worth the extra $100.00, but still undecided. I'm not totally against the Minn Kota, so thoughts on that would be welcome as well. thanks, in advance

I reset the finder and then selected the transducer and everything works now.

I think 450 and 800 but I'll have to check later to be sure

I bought a used boat that has two Elite 7 Chirps. Under frequency choices I should have High and Low Chirp choice but I don't. Does anyone know why? Thanks,

used the Ardent last weekend and it performed very well, so I'll save the money right now.

any of my spinning set-up's that had full Flouro were re-spooled with 20# braid. My finesse rods very from 7 to 10# Sniper flouro Leaders.