Does anybody make a pre rigged power shot hook setup similar to the drop shot hooks with the barrel swival made by vmc and I believe there is another one. Something like a Tokyo rig bit with a longer wire or a spot to put heavier line in for drop shots

Power shot rigs are so simple for me as I use braid-to-leader. Tie a hook on where you want it, thread a bullet weight on pointy end down, tie a split ring below the bullet weight...done.

I use a quality snap at the end of my line. Pre-rig some weights at desired length of line to a quality snap.

Rig favorite soft plastic to line end clip along with the pre-made weight. All set!

 

I also look close at the whole rig so the weight is clipped in such a way that with the weight dangling, the soft plastic is what you'd like to see as correct side up. Not a big deal really, but it's what I do.

 

 

Karl

 

Like this?

Ends up looking like that!

 

 

 

Karl

8 hours ago, MN Fisher said:

Power shot rigs are so simple for me as I use braid-to-leader. Tie a hook on where you want it, thread a bullet weight on pointy end down, tie a split ring below the bullet weight...done.

 

Yup - it's simple. I like to use snaps so I can quickly change from soft plastics to a crank or topwater. Not that tying is all that difficult. Gotta pick what works for you.

 

On occasion when set-up for Bubba Shot, my weight will get caught in a bush behind me when fishing from shore. Nice to just grab a new weight-n-clip and I'm back fishing in seconds!

 

 

Karl