.dsaavedra.

wickyman, what dremel tools are you referring to? is it an attachment for a regular dremel rotary tool? or is it a whole different tool?

i have a docker's wallet that i like. i don't carry it much though unless i'm going out. its a bi-fold with an ID flap.

what are your favorite everyday carry knives? i'm looking for a new one.

Awesome. Didn't know you knew about acid bath. yeah! they're one of my favorites.

oh listen to Scream of the Butterfly by Acid Bath, its my second favorite song of all time!

hahahaha. they're all good songs though.

dude nice baits Barry, thats alllllll i gotta say.

;D ;D ;D

no kidding!

duuuuuuuude w t f are you talking about......

wow those look really good. wish i could see a better picture of the patterns on them, but the baits look AWESOME! too bad there are no academy's around here....

The most common fish story. I had one bigger, but I lost him at the boat... Did you measure the fish when it was in the water? The poster estimated the length. For all we know that girl could be 200-300 lbs. : haha no i didn't "lose it at the boat" like most fish stories go. i actually had this fish in my hands. i saw the entire length of it, and while i didn't measure it, it was lined right up parallel to the side of the boat and i would be safe to say it was around 30 inches.

they're talking about marry-go-round like a carousel, motorized ones, and talking about like oscillating floor fans, not ceiling fans. i got a 19

fail.

"what is wrong with my fish?" - its a $2 goldfish : ;D

no prob, and thanks .

no way, these are good!

these look super. what are you using for your stripes? i tried using a 'fro pick and it was pretty tricky.

your best yet 8-)

no target coatings is not the same stuff. your stuff is a waterbased epoxy, target coatings is a waterborne polyurethane. when i said it was the same way i meant target coatings takes over 4 days to reach full hardness, takes 3 coats for a good finish, and wouldn't stand up to toothy fish. 13 bucks for 4oz of UV protected is really expensive dude. a quart (32oz) of target coatings is 23 bucks.

target coatings sc9000 is about the same way.

nope. acetone or paint remover might help but that will gum it up. no need to take the paint off really. just sand the finish with 400 grit so the entire thing is nice and scuffed up, then prime and paint.

no it does not dry hard. it stays somewhat flexible. i was pretty disappointed when i found this out. i've heard people say that it dries to about the same hardness of etex (i've never used etex so i couldn't say). when this stuff is fully cured you can put a small dent in it with your thumbnail, but the dent kinda "raises" itself out. i ordered it from www.targetcoatings.com what are you using now? devcon makes a great topcoat if you prepare it right. i was tired of the application process and wanted to try out dipping. 6 packs for $18 is a pretty good deal.

looks great! you're good with rattle cans man. i think the hump looks a little silly though lol ;D

yeah i dip it. 3 coats. has held up fine for me but i haven't tested it much at all.