Sharkbite

side joint #9

inside bow #8

inside bow #7

Side Joint #6

Rivets on transom #5

inside transom #3

inside transom #4

inside transom #2

inside transom #1

Yea, I need to get over there and check that stuff out. LBH what will work and hold up for a while?

so is this what everyone agrees on just to put a coat of epoxy? Whch do I use this site you posted has many? Do I need to sand all the old paint? do I still need to replace the rivets?

So can ijust drill out the rivets were the major leaks are then re do those areas? I am not to worried about the side joints only the transom and bow is were it needs repair. I am going to get those pics up tomorrow ok

Hey BB I thought the same thing but I want to keep this one for about 5 years till my car note is done then I can get a nice boat.

Hey guys the leaks on the sides on the inside of the boat have silacone on them. Should I take it all off then take the pic or just take the pic first?

ok guys i will get more pics my next day off anf I did take the boat down from that position as well. I can also work on my boat in the basement threw the winter. Isn't there a sealer I can use guys? I have never used rivets beforeo I would need alot of help I think. like I said the leaks aren't nearly as bad on the water. So JB weld won't fix this?

Hey you got a link for the article I would like to read it.

LBH In the pics only the bow to the transom are sanded b/c I when I took the boat out on sunday there was no water coming in from the side joints. Once I filled it up with water it started to leak. I think this is due to the pressure and not any damage. Also me and Muddy are wondering why does it leak more when filled with water but when it was on the lake after 6 hours I only had about a cup of water in the bottom. The leaks were at the bow and transom only when the boat was on the lake. While sanding there was no lose rivets or any holes it look more like old sealer or something like that.

yea i have the same concerns for the leaks and the seat. I have been looking around for a 6'' swivel and haven't found one. Muddy over these next few months I am going to remodel the whole boat. I need to replace every peice of wood and mount the front motor on as well. I am going to get 2 seats like yours and I am painting the trailer and boat. Most of the work I've done so far is on the trailer to make it legal. It is my goal and a great project. For the leaks I know it was leaking 4 times faster today then when we were out the other day. Also some of the leaks in areas 3 and 2 are at or abover water line. There is very little pressure there but I still would like to seal it once and for all. The major problem is the bow and transom That I could tell. Hey guys I hope the pics are good enough and we can get a solution. Also if any one knows how to put more the one picture with a post I would love some instruction. I am worried that my post will get deleted for posting too much.

#17

#16

#15

#14

#13

#12

#11